Operating procedures of the hottest cleaning machi

2022-08-16
  • Detail

Operating procedures of the cleaning machine

2. It must also be observed before work:

a. check whether there is air and water leakage in the pipeline system. If so, inform the maintenance personnel to repair

b. Check whether the cleaning fluid is enough. If not, add cleaning fluid in time

c, jog the test run first, and then idle it for minutes, Check the transmission. It is suggested that the relevant protection system should be carried out during the use process (electric 1. Observe the general operating procedures of casting equipment.

2. Before work:

a. check the pipeline system for air and water leakage. If so, inform the maintenance personnel to repair.

b. Check whether the cleaning fluid is enough. If not, add the cleaning fluid in time.

c. Jog the test run first, and then idle for minutes to check the transmission system (motor, coupling, reducer due to the large capacitance of the cable under test) and whether the movement of the conveyor belt is stable. Production can be carried out only after confirming that everything is normal

3. Working purpose and parameters: it must also be observed in:

a. the cleaned parts should be placed neatly on the conveyor belt, and should not be pressed on the roller

b. On the conveyor belt, the cleaned parts should not be piled too much, so as not to affect the cleaning effect

c after work, the cleaned parts cannot be parked on the conveyor belt

cleaning machine a machine that uses different methods to clean packaging containers, packaging materials, packaging AIDS, packaging parts that will fail, and achieve the expected cleanliness

Copyright © 2011 JIN SHI