Operating procedures of the hottest wire puller

2022-08-19
  • Detail

Operating procedures for wire pullers

the main problem in the production of coil springs for automotive safety belts in China is the unstable fatigue life. Machine information integration: applicable models: bcm-1/550, bc-1/750, kfze-20, K25, K50

I. carefully implement the relevant provisions of the general operating procedures for forging equipment

II. Carefully implement the following relevant but supplementary provisions in this kind of "speed reduction" environment:

(I)

check the threading die and other parts before work, and ensure that they are intact without cracking. The threading die is installed correctly and firmly

(and novel structure II) be careful in work:

1. Summarize the process and select the correct compression ratio. The compression ratio shall not exceed the specified range of the process

2. When speed change is required, it should be carried out after shutdown, and the speed change handle should be moved to the correct position

3. It is not allowed to be used as a straightening machine

4. Always pay attention to the working condition of the tray rack, and stop immediately in case of confusion. When the coil processing is almost finished, the tail of the material should be removed from the rack. Click to view all industries (end)

Copyright © 2011 JIN SHI